1.
Remove the standard adapter plate
A
and
counterpiece
B
by removing bolt
C
, bolts
D
, washer
and nut
E
from the rear frame.
2.
Position the adapter plate for the rear wheel
extension
F
at the required height and tighten
securely on the counterpiece
G
using bolts
H
and
bolt, washer and nut
I
.
3.
Install the adapter sleeve
J
(with distance sleeve
K
if necessary) at the required position in the adapter
plate and tighten the nut
L
.
C
= 13 Nm
D
= 13 Nm
E
= 13 Nm
H
= 13 Nm
I
= 13 Nm
L
= 33 Nm
Parking brakes and mudguard must be repositioned if the position of the rear wheel is changed.
6.8.5 Changing the Wheel Camber
A wheel camber of either 1° or 3° is possible.
Open-end spanner (18) / Socket spanner (19, 22)
■■□
The wheel camber is changed by replacing the adapter sleeve:
1.
Remove adapter sleeves
B
or
C
on both sides.
2.
Insert new adapter sleeves and on both sides at the
required, identical position in the adapter plate
A
.
3.
Fasten securely with nut
D
.
D
= 33 Nm
6.8.6 Ensuring the Rear Wheels are parallel
Open-end spanner (18) / Socket spanner (19, 22)
■■■
1.
Loosen the nut of the adapter sleeve
on both sides, see
6.8.5 Changing the Wheel Camber, page 45
.
2.
At the height of the center of the axle, measure the
distance between the rear wheels at the front and back
(x, y).
Distance, back > distance,
front (y > x)
Turn adapter sleeve
towards rear (viewed
from above)
Distance, front > distance,
back (x > y)
Turn adapter sleeve
towards front (viewed
from above)
3.
In accordance with the table, turn the adapter sleeves
so that the distance between the rear wheels is the
1659353-A
45
Содержание Compact FF
Страница 55: ...Notes ...