Kurzweil Flash Play PC4, Руководство музыканта

Страница: 234 / 335

Multi Edit Mode
FX Page
7-28
Aux FX Channel
The Aux FX Channel determines the MIDI channel that will be used for the Aux 1 and Aux
2 FX Chains. For example, if the Program in channel 2 uses the Chain “25 Basic Delay 1/8”
as an Aux 1 Chain, then setting the Aux FX Channel to 2 allows the programs in all channels
to send their signal to the Aux FX Chain “25 Basic Delay 1/8”.
Keep in mind that the MIDI channel number of each Zone does not have to match the
Zone number. For example, if Zone 1 is assigned to use MIDI channel 5, then Aux FX Chan
must be set to 5 in order to use the Aux FX Chains of Zone 1. To view or change the MIDI
Channel for each Zone, see Channel on page 7-7 .
Aux1%, Aux2%
Use the Aux1% and Aux2% parameters to set the Aux 1 and 2 FX send levels for the
Program in each MIDI channel.
The default setting “[p]” will use the dB level or wet/dry percent send value specified in the
Program of the selected MIDI channel. To override one of these send level values, select the
Aux1% or Aux2% parameter for the desired MIDI channel, and enter a new wet/dry percent
send value (0=fully dry, 100=fully wet). A value of [p] can be set by entering -1 and then
pressing the Enter button, or by using the Alpha wheel or -/+ buttons to scroll below 0.
Note: In most factory Programs, the send level for Aux 1 is controlled by an Aux mod set to
MIDI 28 (Slider 9.) If a send level override is set, it will usually be scaled by the entry value
for Slider 9, with values of 0-127 scaling between 0% wet and the selected send level. To
defeat this behavior, set the Mod Override parameter to ON. This will cause the Program to
use the selected send level value.
AUX1 Override, AUX2 Override
Normally, the Aux Effects Chains are specified by the program on the specified Aux Effects
channel. When Override is set to Yes, the Chain parameter can be selected, allowing you to
choose a different Aux effect Chain.
Set Override to Yes to select an override Aux Chain on this page. Set Override to No to use
the Aux FX chain of the specified Aux FX Channel.
Chain
When AUX1 Override or AUX2 Override is set to Yes, you can select an override Aux Chain
for the corresponding Aux Effect. The Chain parameter can not be selected when Override is
set to No, and “(Prog)” is shown as a reminder that the Chain from the Program on the Aux
FX Channel is being used. Press the EDIT button to edit the selected Chain.