page 16
page 17
Chapter 6
Chapter 6
Layer Mode
If you have already saved a layered voice as a Favorite and want to make a change, select the Favorite first,
then press the
Layer
button to enter
Layer Mode
.
Using the Save Button
Once you have created your layered sound, press the
Save
button located to the left of the screen. The
first empty location in the
Favorites
will be displayed. The display reads:
Save Voice As.. F(
# of empty
location
)
. Press the
+Next
button to choose a different location. Press the
Save
button again to save
the layered voice.
If all Favorite locations have been used, pressing the
Prev-
or
+Next
buttons will step through all six locations, allowing you to
choose one to overwrite.
To change to a different secondary sound, the
Voice
button’s LED must be lit. Choose the category you
want on Row 1 or Row 2 by pressing the
Voice
button to switch rows. Select the category of sound you
desire. Advance with the
Prev-
or
+Next
buttons to find your desired sound.
The new sound chosen is now your secondary sound. Remaining in
Layer Mode
, only the secondary
sound can be changed. You must start over to change your primary sound and create your desired
combination.
To exit
Layer Mode
, press the
Layer
button again.
Volume Balance
This parameter sets the balance volume between the 2 layered sounds.
Press the
Layer
button to enter
Layer Mode
. Press the
Select
▲ button to set the volume between
the layered voices. The display reads
VOL:0
(the default setting) or the last setting selected since the
instrument was switched on.
VOL : 0
Use the
Prev-
button to decrease the volume of the secondary
voice. The range is from
0
to
-9
. Press the
+Next
button to
increase the volume of the secondary voice. The range is from
0
to
+9
. This will allow you to customize the balance between your two
voices.
Layer Octave Transposition
This parameter sets the transposition of the secondary voice relative to the primary voice.
XPOSE: 0
In
Layer Mode
, press the
Select
▲
button until the screen displays:
XPOSE:0
.
To transpose the secondary voice up an octave, press the
+Next
button once. The screen will display
12
. Press the
+Next
button
twice to move up 2 octaves. The screen will display
24
. To lower an
octave, simply reverse the steps by pressing
Prev-
button to change or
lower the octaves for the secondary voice. The default setting is 0, or the last setting selected since the
instrument was switched on.
Saving Layered Voices
Using Favorite Buttons
Once you have created your layered sound, select a
Favorite
button 1-6 to store the layered voice.
Press and hold any
Favorite
button. The layered voice is now stored in that location.
To Exit
Layer Mode
, press the
Layer
button again.
LAYER Mode