Kurt SCD430, Руководство по эксплуатации

Страница: 15 / 19

3 to 6 months
MAINTENANCE SCHEDULE
11. Install the threaded collar. While holding screw from turning, lightly
snug threaded collar to the holding block. Tighten lock screw on the
collar.
12. Inspect the wiper seals (#5, fig. 6) on the nuts. Remove any chip build
up.
13. Oil all exposed surfaces of the screw and apply a small film to the top
surface of the vise bed.
14. Apply a generous amount of grease into the cavity and place the half
sphere segment back in the movable jaw cavity. The flat surface will
match up with the angle of the nut once reassembled.
15. Re-install the movable jaw, assuring the segment is properly in place.
16. While pulling back on the movable jaw, tighten the set screw.
17. Back off the screw 1/8 of a turn counter clockwise. The setscrew must
not be tightened all the way.
18. Close the movable jaws tightly. This will set the segment to its proper
orientation. Open the movable jaws.
1
5