13
| ENLGISH
6. To re-assemble the movable jaw, apply a “glob” of grease to the
under side of the movable jaw in the pocket. Place the spheri-
cal segment in the mating pocket and push into the grease. The
grease will hold the segment in place when the jaw is turned over
to replace.
7. Tip the jaw so the front of the jaw (the side with the jaw plate)
is on the vise bed. Lower the jaw on to the bed so that the seg-
ment contacts the hook part of the nut and rest the jaw on to the
vise bed.
8. Tighten the setscrew to firmly contact the nut. Back off the
setscrew ¼ turn (approx.) note: DO NOT leave the setscrew tight-
ened firmly to the nut as this may cause improper operation. The
movable jaw is designed to move slightly (pivot side to side) so
maximum jaw plate contact is maintained when clamping out-of-
parallel, sawed, or cast parts.
9. Your vise is now ready for use. Open and close your vise to
check for proper operation. Center the part to be clamped in the
vise and close. Your parts should be centered from side to side to
insure proper clamping. (See Fig. below)
