INSTALLATION INSTRUCTIONS
kurt versen
701 Millennium Blvd,
Greenville, SC 29607
1.888.777.4832
www.kurtversen.com
CAUTION: BEFORE RELAMPING OR REPLACING ANY ITEM
"TURN OFF POWER".
Fig.7 CORRECTIVE ADJUSTMENT
(AFTER INITIAL INSTALLATION)
1. Remove trim or cone sub-assembly.
2. Loosen all 4 screws. (2 on each end)
3. To move fixture up, push up against the housing top.
4. To move fixture down, pull down on the aperture pan.
5. Once in the correct position, tighten all 4 screws.
6. Reinstall trim or cone sub-assembly.
Fig.5a Rotation disk/ Yoke adjustment
1. Releasing "Yoke Locking Lever" allows yoke to pivot from 0 to 30
degrees. Re-engage lever when desired angle is obtained.
2. Releasing "Rotation Disk Locking Lever" allows rotation disk to rotate
360 degrees. Re-engage lever when desired position is obtained.
3. To convert from downlight to adjustable position, remove downlight
locking screw.
Fig. 4
Fig. 5
Fig. 6
Fig. 6a Connector Box attachment
Fig. 5b
View into fixture from below ceiling line
NOTE: Wall Wash trim not shown for purposes of clarity
WALL
Incorrect upper reflector orientation
Correct upper reflector orientation
WALL
ARROW MUST BE
PERPENDICULAR TO
WALL TO BE LIGHTED
KV6963
93079817 REV B
Connector
Box
Housing
Screw
Screw
Wing nut
Rail
(by others)
Internal
vertical
adjustment
bracket
Rail
support
Connector
Box
LED wire plug
Two pin plug
from driver s/a
Torsion
Spring
Trim
Assembly
XTM Bracket
Sub Assembly
Slot
Notch
Twist & Lock
Reflector
Two pin plug from driver s/a
Top of
Heatsink
LED wire plug
Yoke
Safety Spring
(See Fig. 5)
Locking Screw
Rotation Disk
Rotation Disk
Locking Lever
Yoke Locking Lever
Housing
Housing Top
LED Driver
Assembly
Aperture
Pan
Safety Spring
(Push to Release XTM bracket sub assembly)
LED wire plug
Connector
Box
15°
Safety
Spring
Yoke
Upper
Reflector
Upper
Reflector
Yoke
Safety
Spring
‰
‰
‰
‰
XTM LED MODULE 1353
WALL WASH
LED Wire Plug
XTM Bracket
Sub Assembly
Twist & Lock
Reflector
