Küppersbusch WT1458.0W-CN, Руководство пользователя

Страница: 10 / 28

light of the button 8 blinks 3 times and the
message Err is displayed for a few sec-
onds.
Altering an option or a running
programme
It is possible to change any option before
the programme carries it out. Before you
make any change, you must pause the
washing machine by pressing the button
8 .
Changing a running programme is possible
only by resetting it . Turn the programme
selector dial to and then to the new pro-
gramme position. Start the new programme
by pressing the
8 button again. The wash-
ing water in the tub will not emptied out.
Interrupting a programme
Press the button 8 to interrupt a pro-
gramme which is running, the correspond-
ing light starts blinking. Press the button
again to restart the programme.
Cancelling a programme
Turn the selector dial to to cancel a pro-
gramme which is running. Now you can se-
lect a new programme.
Opening the door
After the programme has started (or during
the delay time) the door is locked, if you
need to open it, set first the machine to
PAUSE by pressing the button
8 .
The pilot light 9 goes out immediately and it
is possible to open the door.
If this pilot light remains lit, this means that
the machine is already heating or that the
water level is too high. In any case, do not
try to force the door!
If you cannot open the door but you need
to open it you have to switch the machine
off by turning the selector dial to
O . After a
few minutes the door can be opened (pay
attention to the water level and temper-
ature!)
.
After closing the door, it is necessary to se-
lect the programme and options again and
to press button
8 .
At the end of the programme
The machine stops automatically. Three
blinking
0.00 appear on the display and the
pilot light of button 8 goes off. Some
acoustic signals sound.
If a programme or an option that ends with
water left in the tub has been selected, the
door remains locked to indicate that the
water must be emptied out before opening
the door.
Before you empty out the water, the drum
continues to run at regular intervals until the
water draining.
Follow the below instructions to empty out
the water:
1. Turn the programme selector dial to
O .
2. Select the draining or spinning pro-
gramme.
3. Reduce the spin speed if needed, by
pressing the relevant button.
4. Press button 8 .
At the end of the programme, the door is
released and can be opened. Turn the pro-
gramme selector dial to
O to switch the
machine off.
Remove the laundry from the drum and
carefully check that the drum is empty. If
you do not intend to carry out another
wash, close the water tap. Leave the door
open to prevent the formation of mildew
and unpleasant smells.
Drying only
The recommended load size is 3 kg for cot-
tons and linen, and 2 kg for synthetic items.
Note! By pressing Drying Time button it
is also possible to dry up to 4 kg of cot-
ton items (see the «Drying Programme»
table).
The water tap must be open and the
drain hose must be positioned in the
sink or connected to the drain pipe.
1. Load the laundry.
2. Select a spin cycle at the maximum
spin speed allowed for the type of laun-
dry in order to obtain the best drying
performances.
3. Select the drying programme for Cot-
tons or Synthetic in the Drying sector of
the programme selector dial.
4. If you wish to select an electronic dry-
ing, press the button 3 until the pilot
light corresponding to the required dry-
ness degree illuminates.
5. If you wish to select a timed drying,
press button 4 until the time you want
appears on the display (see the «Drying
10