Installing the chimney
The chimney is inserted into the hood body and fastened with the suspensi-
on angles to the wall under the room ceiling.
–
Set the suspension angles to the
width of 26 cm with the screws
(E).
–
Fasten the suspension angles with
the angle cover facing upwards
with wall screws and dowels. Mo-
unt the angle directly under the
ceiling so that the chimney is
flush with the ceiling.
–
Insert the chimney into the groove
between the housing and the
glass shelf with the lower edge on
the hood body.
–
Extend the upper chimney up-
wards and screw tight to the sus-
pension angles with the screws (F).
Screwing the control element tight
–
Reach through the right-hand side
of the opening at the bottom of
the hood body and tighten the
control element with the knurled
screws.
Make sure that all the control buttons protrude slightly forwards out of the
chimney.
Inserting the metal fat filters
Before you install the filters again, you should read off the serial number
and the model designation on the rating label and enter them on page 16.
Only appliances with recirculation mode
–
Place an activated charcoal filter
in each filter cover and secure
with the holders.
All appliances:
–
Mount both filter covers. To this
end, insert the two brackets of
one cover into the openings provi-
ded in the lamp holder, press the
filter upwards and then push in-
wards until it is firmly in position.
Mounting the ornamental glass
–
Undo the fastening screws on the
holders for the ornamental glass
and loosen the holders.
–
Insert the ornamental glass into
the holders from above and
tighten the screws slightly.
–
Carefully tighten the fastening
screws without using any force.
Danger!
Do not tighten the screws too much. If the glass is under
stress, it might possibly shatter and cause injury.
KD 965.1 / KDEM 965.1
19
