Displays which depend on the hours of ser-
vice
The cleaning interval for the fat filter
The appliance can only function correctly if the fat filter is cleaned regularly.
After about 100 hours of operation the control lamp highlighted below flas-
hes so that you remember to clean the fat filter.
–
Switch the hood off and pull out the mains plug or switch off the fuse.
–
Clean the fat filter (see section “Cleaning the metal fat filter”).
–
Then press the “Reset” button to reset the working hour counter and
switch off the control lamp.
The cleaning interval for the activated charcoal filters
If you use the hood as a recirculating air unit, the two activated charcoal filters
must be regularly replaced in addition to the fat filter being cleaned. The
control lamp for the activated charcoal filters flashes after about 200 working
hours to remind you.
–
Switch the hood off and pull out the mains plug or switch off the fuse.
–
Clean the fat filter (see section “Cleaning the fat filter”) and change the
activated charcoal filters (see section “Changing the activated charcoal
filters” on page 18).
–
After changing the filters, press the “Reset” button to reset the working
hour counter and to switch off the control lamp.
General instructions on use
in extraction mode
in recirculation
mode
Appliance
Switch on
appliance
on starting cooking
on starting cooking
Switch off
appliance
ca. 5 min. after
finishing cooking
ca. 15 min. after
finishing cooking
Position of
Door
open
closed
Window
closed
open
The room
air is
cleaned of
Moisture
X
—
Heat
X
—
Fat
X
X
Odours
X
X
Cleaning and maintenance
Danger! Before all cleaning and maintenance work disconnect
the appliance from the power supply by pulling out the mains
plug or by switching off the household fuse!
Caution! Do not use any abrasive or sharp cleaning agents!
–
Clean the hood on the inside and outside with a damp cloth and a mild
liquid detergent.
Control panel
–
Carefully wipe the control panel now and again with a soft cloth which is
free of fluff.
Glass surfaces
–
Clean the fume trap and the glass shelf with a damp cloth and a little
hand detergent or one of the usual glass cleaning agents.
Stainless steel parts
–
Clean stainless steel parts with a damp cloth and a little washing-up
liquid. Then wipe dry. Use one of the usual stainless steel cleaning
agents from time to time.
Cleaning the fat filter
The metal fat filter must be cleaned when the relevant control lamp on the
control panel flashes, but at the latest every 2 months.
–
Undo the two screws holding the
metal mesh under the hood.
–
Remove the mesh with the fat filter.
–
Remove the support bracket and
pull out the fat filter.
Support bracket
IKD 954.1
17