6
GKS 324.0/GKS 644.0 Installation Natural gas
Installation
It’s quicker and easier to install these units by using clips. You can perform
all installation work from above.
– Make a clean cut into the counter top. (see “Installation dimensions ”).
– Make sure that the gasket is properly seated. “See Gasket” on page 3.
– Insert the clips on the cooking area counter top cut-out as shown in the
diagram on the previous page. Use the exact measurements as indicated.
GKS 324.0
GKS 644.0
Up to 37 mm (1-3/8") worktop:
38 mm (1-1/2") or more worktop:
Detail of the cook top with clips screwed on:
– Insert the rear edge of the
cook top and carefully lower.
At the same time press in
the clip with both hands.
– Press hcook top downward
until it rests completely on
the worktop.
F
If the worktop cut-out should be a little too large, it’s possible to increase
the preliminary spring tension of the clips by screwing them down.
– Place the burner cover, the saucepan support(s) and attachment carefully
in the correct position.
– Pin up the control knobs.
– Insert plug into the socket
Initial start-up
– Turn on the gas connection tap, and insert the plug into the shockproof
socket.
Before the appliance is put into operation, it must be checked by a gas tech-
nician to make sure it’s functioning properly and there is no gas leakage. The
appliance is then ready to be put into operation.
[
Leak testing of the appliance shall be conducted according to this instal-
lation instruction.
Using the operating instructions, the technician should demonstrate operating
functions to the user. The operating instructions should then be given to the
operator.
Testing the appliance’s functions
[
After you have completely reassembled the appliance, you must test all
of its functions!
– Put the appliance into operation as described in these operating instruc-
tions.
– Check the appliance and the installation for any gas leaks.
– Check the burners for signs of over-ignition and a steady flame (do not for-
get to check them on low flame, as well).
