22
Open the drawer and
take out all the
accessories
and remove the packing
material.
Attention!
The front surface of the crockery
heater may be wrapped in a
protective film
.
Before using the crockery warmer for the
first time, remove this film carefully.
Make sure that the crockery warmer is
not damaged in any way.
Check that the
drawer opens and closes correctly. If you
find any damage, contact the Technical
Assistance Service.
Attention: the power socket should be
easily accessible after the crockery
warmer has been installed.
The crockery warmer should only be built-in
in combination with those appliances
indicated by the manufacturer.
If it is fitted
in combination with other appliances, the
guarantee is no longer valid since it is
impossible to guarantee that the crockery
warmer will work correctly.
INSTALLATION
To build-in the crockery warmer in
combination with another appliance there
must be a fixed, interim shelf in the housing
unit to support the weight of both
appliances.
The appliance to be combined with the
crockery warmer will be placed directly on
the latter without any need to have a
separating shelf.
To build-in the appliance which is combined
with the crockery warmer, follow the
instructions set out in the respective
instructions and fitting booklet.
The relevant installation dimensions are
indicated in
mm in the diagrams shown at
the end of this booklet
. Proceed as follows:
1. Place the crockery warmer on the shelf
and slide it towards the interior of the
niche in such a way that it is centred and
completely lined up with the front of the
unit.
2.
is properly levelled and is sitting evenly
on the shelf.
3. Open the drawer and fix the crockery
warmer to the sides of the unit using the
two screws provided.
ELECTRICAL CONNECTION
The crockery warmer is equipped with a
power cable and plug for single phase
current. We advise that the
plug is
connected to a socket that is easily
accessible after installation.
If the crockery warmer is to be installed
on a permanent basis
it should be installed
by a qualified technician. In such a case, the
appliance should be connected to a circuit
with an all-pole circuit breaker with a
minimum separation of 3 mm between
contacts.
The data necessary for the electrical
connection are
described on the crockery
and these
must be compatible with those of the power
outlet you are going to use.
WARNING: THE CROCKERY WARMER
MUST BE CONNECTED TO EARTH.
The manufacturer and retailers do not
accept responsibility
for any damage that
may be caused to people, animals or
property if these installation instructions are
not observed.
