10/22
T1-88-05
Internal use only
Configuration: LISA (Bora)
Standard procedure for manual configuration:
Before you can begin with configuration, you will need to
remove all the pans from the cooking zones.
You need a suitable induction cooking pan which covers
at least 80% of the biggest diameter of a cooking area
(e.g. inductor 200mm > pan size > 160mm).
Configuration can be triggered within 2 minutes of swit-
ching on the power supply. The controls are not switched
on when you do this. The displays will all remain dark.
1. Press the minus key (5) and keep it pressed.
2. Press all the select keys anti-clockwise, beginning with
the cooking zone (9) at the front right. A buzzer will
sound in confirmed each time a key is pressed; a faulty
entry is acknowledged with a double buzzer signal. In
this case entry to the service menu will need to be
repeated.
In the cooking zone displays, a "C" will show for cooking
zones that have not been configured and *-* will show for
configured cooking zones.
The cooking zone to be configured can be selected with
the cooking zone selection key. When a key is pressed,
the "C" in the corresponding display will start to blink.
Cooking zones that have already been configured cannot
be configured again. If configuration is faulty, e.g. becau-
se the pan was placed on cooking zone other than the in-
tended zone, all the configurations will need to be deleted
again.
To do so, press the minus key ( 5 ) and the plus key ( 6 ) for at least 2 seconds.
While you are pressing, an "E" will appear on all the cooking zone displays. The "E" in the cooking zone
displays will blink until all the induction modules have been returned to their initial state, then the display
will switch to "C". The cooking zones must now be configured again.
A pan must now be placed on the relevant cooking zone within 20 seconds, so that the induction module
can recognise the corresponding position. The display will show "-" once the position has been recog-
nised. Under no circumstances may two pans be placed on the cooking zones at the same time, since
in this case they will both be allocated to one cooking zone. If this should happen, all the configurations
will need to be deleted and restarted from the beginning again.
The procedure is repeated for all the cooking zones, until the last cooking zone automatically leaves the
configuration menu after configuration. The configuration menu can also be exited by pressing the power
key. If a key is pressed the menu will be exited after two minutes.
Sensor keys
1 reduce ventilation
3 increase ventilation
4 hob on/off
5 reduce cooking level timer value
6 increase cooking level timer value
9 selsct cooking zone