Kuppersbusch KD 12660.0GE, Инструкция по использованию и монтажу

Страница: 10 / 16

26
What to do if trouble occurs GB
What to do if trouble occurs
Interference with and repairs to the hood by
unqualified persons are dangerous as they can
result in electric shock, or short circuit. Do not
interfere with or try to repair the appliance; this
could cause injury to persons and damage to the appliance.
Therefore always have such work done by a qualified electri-
cian, e.g. Customer Service.
Below are some tips for rectifying faults yourself.
The hood does not function at all.
• Is the plug in the socket?
• Has the fuse for the domestic wiring system tripped?
Has the hood developed a malfunction.
• Switch the hood off with the buttons and disconnect it from the
mains for a few seconds by removing the plug or switching off
the fuse.
The suction power is not strong enough.
• Has the right fan speed been set?
• Has the metal grease filter been cleaned?
• Was the charcoal filter replaced in good time?
• Is the air removed from the kitched replaced with a sufficient
supply of fresh air so that no negative pressure develops?
• Are the air outlets blocked?
• During installation, was the outlet air duct miscalculated or not
properly installed? (e.g. diameter too small, exhaust air pipe
too long or exhaust air duct too angled)?
The hood is suddenly much noisier during
operation.
• Does sufficient fresh air flow into the kitchen when the extrac-
tion air mode is operated?
Have operation noises become louder with time.
• Have the maintenance cycles of the filters been observed to
allow air to get in at all?
The LED lamp does not work.
• Has the fuse for the domestic wiring system tripped?
• Was the new LED lighting properly connected to the power
supply (plug connection)?
When the hood is switched on, two LEDs will
blink alternately for a few seconds (saturation
display).
Please clean the metal grease filter or replace the charcoal filter.
Pressing the
Minus button and the Plus button
simultaneously will clear the counter of the saturation display.