EKE 81.2
19
Insert the hob
– Carefully position the hob in the recess and firmly fasten to the worktop with
the appropriate attachment elements.
– After attachment check the seal with the worktop.
Attachment with screws
– Insert the angle nuts and introduce the glass ceramic hob from above. Then
fasten the hob with screws and attachment brackets from below (see illu-
strations).
– Align the glass ceramic hob horizontally. There is a risk of breakage if the
hob is canted or subjected to stress during installation!
Attachment with
clips
Drive in the clips
– Align the clips carefully and drive them in with a hammer..
Worktops with more than 30 mm thickness:
With worktops with 30 mm
thickness the clips have to be
screwed down with two screws
(not supplied)!
Inserting the hob
– Position the hob on the left side
(1), align it (2) and insert the
clips (3).
Be careful not to pinch the
connecting cable!
=
It is essential that the hob
rests evenly in the opening,
since strain may cause the
griddle/hob to crack on being
heated up.
F
If the hob is not fixed tightly in the opening
it is slightly too big. In this case screw the
clips with two screws down each (not supp-
lied) to raise the spring tension.
Plug the mains plug into the wall socket.
– Insert the plug into the wall socket.
– The exceeding cable has to be pulled out of the installation area.
Attachment of worktops with an uneven surface
– When installing a hob into an uneven worktop, e.g. with a ceramic or similar
covering (tiles etc.), the seal on the hob is to be removed and the seal bet-
ween the hob and worktop made with plastic sealing materials, such as
heat-resistant silicone rubber (not included in scope of delivery).
– Clean the surfaces to be sealed in accordance with the manufacturer's in-
structions on the cartridge. Apply the compound in a continuous strip, pres-
sing it firmly against the gap to be sealed.
217,5
217,5
295
217,5
217,5
295
