35
EN
Basic settings
Initial Settings
After your steam oven is first plugged in or after a
power failure, the clock display will flash to
indicate that the time shown is not correct.
The oven will not operate until the clock is set and
the water hardness parameter is set.
To set the clock and the water hardness
parameter value proceed as described in the
following chapters.
Setting the clock
00:00
1,3,5
2,4
To set the clock, proceed as follows:
1. Press the
OK
key. The hour numbers will start
to flash (not necessary if your oven is first
plugged in or after a power failure).
2. Turn the rotating knob
+/-
to set the correct
hour value.
3. Press again the
OK
key to set the minutes. The
minute numbers will start to flash.
4. Turn the rotating
+/-
knob to set the correct
minute value.
5. To finish, press the
OK
key again.