36
EN
Basic settings
Water Hardness setting
The appliance features a system that automatically indicates when it is time to descale.
The system can be optimised for households with
very soft water (also through using a water
softening appliance) and very hard water, by
changing the user settings to the relevant range of
water hardness (see table below).
To set the water hardness parameter, proceed as
follows:
1. In
standby
mode press the
Descaling key
(about 3 seconds) The water hardness begins
to flash (not necessary after connecting the
device to the network, or after a power failure).
2. Turn the
+/- Selection knob
to set the correct
water hardness parameter value, according to
the below table.
3. Press the
OK
key to set the parameter (or wait
until the parameter is set by time-out). The
clock is displayed.
Type
Water hardness
Display
Ca + Mg
(ppm)
English deg.
[°eH]
French deg.
[°dF]
German deg.
[°dH]
Soft water
0 to 150
0 to 11
0 to 15
0 to 8
SOFT
Medium water
151 to 350
12 to 25
16 to 35
9 to 20
MED
Hard water
501 to 500
26 to 35
36 to 50
21 to 28
HARD
Safety blocking
The oven functioning can be blocked (for example, to stop it being used by children).
00:00
1,2
1. To block the oven, press the
Safetyblock
key
for 3 seconds. You will hear a sound signal and
the
display
will show the word “SAFE”. The
oven is blocked in this state and cannot be
used.
2. To unblock the oven, press the
Safetyblock
key again for 3 seconds. You will hear a sound
signal and the
display
will show the clock
again.
The clock can be seen by pressing briefly the
Start/Stop
key.