14
TEchnical passporT
English
refrigerator nsFF 195752
Problem
Possible cause & Solution
A layer of frost
occurs in the
compartment
Check that the air outlets are not blocked by food and
ensure food is placed within the appliance to allow
sufficient ventilation. Ensure that door is fully closed. To
remove the frost, please refer to cleaning and care chapter.
Temperature inside
is too warm
You may have left the doors open too long or too
frequently; or the doors are kept open by some obstacle; or
the appliance is located with insufficient clearance at the
sides, back and top
Temperature inside
is too cold
Increase the temperature by following the "Display
controls” chapter.
Doors cant be
closed easily
Check whether the top of the refrigerator is tilted back by
10-15mm to allow the doors to self close, or if something
inside is preventing the doors from closing.
Water drips on the
floor
The water pan (located at the rear bottom of the cabinet)
may not be properly leveled, or the draining spout (located
underneath the top of the compressor depot) may not
be properly positioned to direct water into this pan, or
the water spout is blocked. You may need to pull the
refrigerator away from the wall to check the pan and spout.
The light is not
working
•The LED light may be damaged. Refer to replace LED
lights in cleaning and care chapter.
•The control system has disabled the lights due to the door
being kept open too long, close and reopens the door to
reactivate the lights.
FAULT DISPLAY
Fault display shows as following under Fault mode:
ERROR CODE
ERROR TYPE
UC
Communication failure or model mismatch
RS
Sensor failure (refrigerating chamber)
CS
Sensore failure (Drinks box)
FS
Sensor failure (freezing chamber)
Fd
Defrosting sensor failure
FF
Fan failure
FH
Defrosting failure
