Kunzle & Tasin Bona Scorpion DCS, Руководство по эксплуатации, Страница: 14 / 32

14 bona.com
Bona Scorpion DCS Manual
This machine only operates with the voltage and frequency shown on the machine data plate. Before
connecting the cable to the power supply ensure the correct voltage and frequency
are available.
DO NOT expose the machine to rain. This machine is intended for dry use only.
Keep the machine in a dry building and DO NOT use it in damp or wet places.
If the machine is not connected correctly to the electricity network, death due to electrocution may
occur. To prevent electric shocks always use a grounded three wire electrical system. For maximum
protection against electric shocks use a circuit protected with a differential cut-out switch.
Tampering with the grounding plug in any way may result in death from electrocution. DO NOT cut,
remove or break the grounding plug. If the socket does not match the plug consult a
qualified electrician.
Do not use the machine if the switch does not open and close.
Instructions for electrical connection
If the machine is used with a damaged plug or power supply cable, death may occur from electrocution.
If cables or plugs are worn or damaged in any way, have them replaced by the manufacturer or certified
machine repair center in order to prevent risks to safety.
Commencing Operation (Cont.)
Cables, extensions and plugs
Using the machine with unsuitable cable cross-sections and/or excessively long cables may cause injury or
damage to people or objects.
The machine must never be moved using its cable and the cable must never be pulled when disconnecting
from the socket.
Keep the cable away from sources of heat, oil and sharp edges.
Only use approved cables. The maximum recommended cable length is 10m; for greater lengths use cables with a larger
cross-section.
MACHINE WITH 230V~50Hz MOTOR
For machines with a 230-240V~50Hz motor (EU), a HO5VV-F 3x1.5mm
2
HAR-approved power supply cable must be used along with an approved
SCHUKO 2P+E 16A 200÷250V plug.