kunzel PK 10, Руководство по установке

Страница: 4 / 32

1 Installation manual pellet boiler
1.1 Usage in compliance with statutory regulations
This pellet boiler is approved for the operation of an open or closed circuit hot water heating system with
a permissible operating pressure of up to 3 bar and a maximum flow line temperature of 95 ◦ C.
It is not permitted to operate the pellet boiler without a return flow booster. The operation of the return
flow booster is to be monitored. A 4-way mixing valve is sufficient as a return flow booster on systems
with a buffer tank.
The boilers supplied by KÜNZEL are stationary units that comply with the WEEE Directive. The elec-
trical and electronic components contained in the boilers do not fall within the remit of this directive and
will therefore not be taken back by KÜNZEL. Please take these components to the recycling depot.
We do not assume any liability for any malfunctions resulting from the use of non-genuine KÜNZEL
components. This particularly applies to control units, external materials handling equipment and fuel
pipes from other manufacturers. We also do not assume any liability for operational difficulties resulting
from inadequate hydraulic and/or exhaust gas systems.
We reserve the right to make technical changes.
1.2 The key controls and components
Figure 1: The key controls and components
1 Boiler thermometer 11 plugged connectors for boiler sensors, serial interface
2 boiler thermostats 12 Igniter safety device
3 Temperature safety limiter 13 Burner quick release lock
4 Mains power switch 14 Burner door
5 Fullness sensor 15 Flame deflector
6 Filling spout 16 Ash pan
4