Kuller KPG22, Руководство пользователя

Страница: 10 / 21

9
4.
Starting the Engine
NOTE Before starting the engine be sure that all the pre-operation check has been done.
Unplug all AC sockets to disconnect loads
Check if the unit has been properly grounded.
Check the level of engine oil and fuel.
Set the fuel switch to ON position (Figure 22)
Set the Choke Lever to OFF position (Figure 23)
NOTE Don
’
t close the choke when the engine is hot.
Set the Ignition Switch to ON position for hand start models; Turn the key-switch to ON
position for E-start units (Figure 24)
Pull up the Starting Handle gently until resistance is felt, then pull it up rapidly. Put back the
handle slowly to avoid damage to the starting system. Turn the key-switch to START position for
E-start Models, for details please consult Chapter 8.(Figure 25)
If the engine fails to start, please turn on the choke lever and repeat what you do in Section 4.6.
WARNING After the engine started, release the starting handle gently to avoid personal injury
and/or equipment damage due to the bouncing back.
Once the engine is started, set the choke lever to ON position. (Figure
26)