This section describes how to pre-set the torque for keys ①, ②, and ③．
For example, to pre-set ① with 250 Nm.
① Turn on the power switch and make sure the display blinks.
Press ① key for 3 seconds.
② SETUP Lamp lights up and the display indicates
the pre-set key and then the previous torque.
(This figure shows 200 Nm as the previous torque).
As soon as the torque is displayed, release the
finger from the key.
③ Press [ + ] or [ - ] key to change the value to 250.
Pressing [ + ] for a few seconds increases
the value quickly.
Pressing [ - ] for a few seconds decreases
the value quickly.
④ To complete the setting, press [ SET ] ② key.
● Please make sure the display blinks [ 0 ] after setting.
To pre-set other keys, repeat above method ① though ④.
Once pre-set the torque, the value is stored until re-set the torque.
(Caution)
The torque range is 140 to 450 Nm. The torque can not be set beyond the range.
Preparation (3)
How to pre-set the torque
Release
Lights up
