KUHN MERGE MAXX 950, Руководство оператора

Страница: 21 / 124

4. - Safety
MERGE MAXX 950
21
KN233BGB_C
Merger
4.2.10 PTO shaft
- Use only PTO shafts supplied with the machine or
recommended by the machine manufacturer.
The protective shield of the tractor PTO stub, the
PTO shaft guards and the protective shield of the
machine input shaft must always be in place and in
good condition.
- Make sure that the PTO shaft guards are secured
with the safety chains provided. Check that the
PTO shaft guard can turn freely a full rotation
independent of the shaft.
Any worn or damaged guards must be replaced
immediately. A worn guard or an unprotected PTO
shaft can cause a serious or even a lethal accident.
- Do not wear loose clothing that could be caught in
the rotating PTO shaft.
- Before attaching or removing a PTO shaft, or
before doing any work on the machine, disengage
the PTO drive, turn off the engine, remove ignition
key and wait for all moving parts to come to a
complete stop.
If the primary PTO shaft is equipped with a torque
limiter or a free wheel, these must be fitted on the
machine side.
- Ensure that the PTO shaft is always correctly fitted
and locked into place.
- Before connecting the PTO shaft, ensure that the
PTO speed (rotational frequency) and direction of
rotation are in line with the machine manufacturer's
recommendations.
- Before engaging the PTO drive, make sure that
there are no people or animals near the machine.
Never engage the PTO drive when the tractor
engine is stopped.
- Do not install any adapter device that results in a
portion of the tractor PTO stub, the rotating PTO
shaft, or the adapter to be unguarded. The tractor
master shield shall overlap the end of the splined
shaft and the added adaptor device as outlined in
the table.
A