KUHN GA 300 GT, Руководство по сборке и эксплуатации

Страница: 13 / 28

- 11 -
Fitting the tines (fig. 4)
The tines (A) must be attached underneath the tine
arms (E) so that their fingers are slanting away from
the direction of rotation (see arrow).
The tines are secured to the arms by using the screw
(B) (M12 x 75), the self-locking nut (G) (M12), the
washer (C) (13 x 35 x 7), the spring washer (F) and the
tine bracket (D). Make sure that all parts are positioned
correctly as shown in figure 4.
FITTING TINE ARMS AND TINES INCORRECTLY RESULTS IN SERIOUS MACHINE
DAMAGE.
Fitting the guards (photo 5)
Attach the guard supports (K) to each side of chassis (O) by means of bracket (F) using the 2 bolts (M)
(M 14 x 30) and one bolt (D) (M 12 x 30) as shown in photo 5. Attach the half guards (L) to each side of the chassis
(O) using bolts (P) (M 10 x 30) with reinforcing plates (Q) located inside the chassis (O). Next attach the other end
to support (K) using bolts (R) (M10 x 30) (photo 5). Do not forget to use the locking washers and nuts.
DO NOT FORGET TO POSITION LOCK WASHERS (M 14 and M 10) AND NUTS (M 14 and M 10) CORRECTLY.
Next fit red reflectors (C) and white reflectors (G) using countersunk head screws (M 5 x 25) and self-locking nuts
(M 5).