Kudux Hot Beam 10R, Руководство пользователя

Страница: 10 / 15

WWW.KUDUX.COM 10
2.4.4. Test light
Enter the page as shown in Figure 10, Light will into test mode, in this mode, the light does not
receive the data for DMX controller.:

PAN: range for 0 to 255;

TILT: range for 0 to 255;

FOCUS: range for 0 to 255;

COLOR: range for 0 to 255;

GOBO: range for 0 to 255;

PRISM: range for 0 to 255;

FROST: range for 0 to 255;
；

STROBE: range for 0 to 255;
Figure 10 page of Test
2.4.5. Set light run parameter
Enter the page as shown in Figure 10, set the parameter of light:
Pan Invert: Reverse PAN move.
Tilt Invert: Reverse TILT mover.
Rectify enable
：
set as ‘OFF’, PAN or TILT will disable position rectify function. As ‘ON’,
when PAN or TILT lose steps, light will rectify auto.
Pan Offset: Set PAN original position.
Tilt Offset: Set TILT original position.
Lamp up when: Select lamp on mode, includes 3 mode: power on, after reset done
and manual
；
Factory setting: restore all parameter to factory setting.
Figure 11 page of run parameter