1
2
3
4
7
5
6
BEFORE BEGINNING THIS
INSTALLATION PLEASE:
Insert spiral cam as
shown in the image
Slide the main height
adjuster block into the base
of the wall post, it will “Click”
when engaged
When fitted the
height adjuster
block should be
flush with the base
of the wall post
1
2
3
Insert the height adjustment blocks into the base of the wall posts as
shown. You will need to lift the wall post slightly to allow space to fit
the height adjustment block.
TOP
BOTTOM
SCREW
PORTS
X1
X2
PLASTIC
SEAL
OPEN SIDE
FIXED PANEL
SIDE
Remove
the fixed panel
patches from the fixed glass
(glass without handle) by
removing the allen key screws. Keep
the inner patch covers safe. Slide x1
Stop Block into each rail as shown,
and then x2 Fixed Panel Patches into
each rail as shown. You do not need to
secure these fixings into the rail at this
stage.
This stage is best carried out
against a wall. Start off with the
bottom rail and ensure that the
outer face of the rail is facing
away from the wall.
Identify
both wall posts. The
wall post with the plastic
flipper seal as shown will be
the opening side of the enclosure,
the one without the seal will be the
fixed panel side. Please ensure that
the wall post
without
the flipper
seal is to go to the end of the rails
with the pre drilled hole as shown in
stage 4.
Secure the wall posts
to the
rails using the X8 No.6x30PH
screws from the screw
Assembly Pack.
Please ensure that
each screw locates into the relevant
screw port in the rail as shown. We
recommend that you start with the top
rail.
To help with assembly
insert the rails into end wraps as shown. The
rails are handed, the fixed panel end can be identified by the pre drilled
hole at the end. These instructions show a
Right Hand Entry
Pre drilled
hole viewed
from inside
Cut out
each end of the end
wraps where shown. These
will help with the assembly
of the enclosure. If you have help
then these may not be necessary.
K U D O
S
Stop block from
installation pack
Fixed panel patch
from fixed glass
?
Ensure you have read and
understood these instructions
?
Check that the tray has been
silicone sealed as instructed
?
Check all of the frame work and
glass for visible signs of damage
?
Decide on the handing of the
shower enclosure
?
Check that the enclosure is of the
correct size to suit the installation
?
Be sure that you have all the
required tools to complete the job
If you need to report a fault you
must do so BEFORE installation.
If there is anything you are not
sure about then please call the
Kudos Helpline
Ensure that the
screws are fully
tightened
