Kubota WSM STa-30, Руководство по ремонту

Страница: 250 / 359

7-S11
ST
α
-30 · ST
α
-35, WSM BI-SPEED TURN
[3] SERVICING
(1) Bi-speed Hydraulic Clutch Pack and Gears
Checking Bearing
1. Hold the inner race, and push and pull the outer race in all
directions to check for wear and roughness.
2. Apply transmission fluid to the bearing, and hold the inner race.
Then, turn the outer race to check rotation.
3. If there is any defect, replace it.
W1024036
Clutch Disc Wear
1. Measure the clutch disc thickness with vernier calipers.
2. If the thickness is less than the allowable limit, replace it.
W1024320
Steel Plate and Pressure Plate Wear
1. Measure the steel plate thickness with vernier calipers.
2. Measure the pressure plate thickness with vernier calipers.
3. If the thickness is less than the allowable limit, replace.
W1024487
Piston Return Spring Free Length and Tension
1. Measure the free length of the piston return spring with vernier
calipers.
2. Place the piston return spring on a spring compression tester and
compress to the specified length, and read the gauge.
3. If the measurement is less than the allowable limit, replace.
W1024789
Clutch disc wear
Factory spec.
1.915 to 2.085 mm
0.07539 to 0.08209 in.
Allowable limit
1.4 mm
0.055 in.
Steel plate wear
Factory spec.
0.95 to 1.05 mm
0.0374 to 0.0413 in.
Allowable limit
0.8 mm
0.031 in.
Pressure plate wear
Factory spec.
1.95 to 2.05 mm
0.0768 to 0.0807 in.
Allowable limit
1.8 mm
0.071 in.
Piston / return spring
free length
Factory spec.
44 mm
1.73 in.
Piston return spring
tension
Factory spec.
638.7 N / 26 mm
65.13 kgf / 26 mm
143.6 lbs / 1.02 in.
Allowable limit
539.4 N / 26 mm
55 kgf / 26 mm
121.3 lbs / 1.02 in.
KiSC issued 11, 2006 A