Kubota RTV400, Руководство оператора

Страница: 74 / 91

55 PERIODIC SERVICE
B
Replacing Engine Oil Filter
To avoid personal injury:
A
Be sure to stop the engine before changing the
oil filter cartridge.
A
Allow engine to cool down sufficiently, oil can
be hot and can burn.
1. Park the vehicle on a flat surface and raise the cargo
bed. Shut off the engine and remove the key.
2. Remove the oil filter.
3. Put a film of clean engine oil on the rubber seal of the
new filter.
4. Tighten the filter quickly until it contacts the mounting
surface.
Tighten filter by hand an additional 1/2 turn only.
5. After the new filter has been replaced, the engine oil
normally decreases a little. Make sure that the engine
oil does not leak through the seal and be sure to check
the oil level on the dipstick. Then, replenish the engine
oil up to the prescribed level.
A
To prevent serious damage to the engine, use only a
KUBOTA genuine filter.
B
Checking and Cleaning Engine Cooling
Air Inlet and Engine Cooling Fin
To avoid personal injury:
A Park the vehicle on a firm and level surface.
A
Stop the engine, remove the key and apply the
parking brake.
A
Allow the engine to cool down sufficiently
when checking and cleaning.
A Engine cooling air inlet and engine cooling fin must be
clear of debris to prevent the engine from overheating.
1. Raise the cargo bed, and push the safety support into
the latch slot to lock.
2. Check the engine cooling air inlet for dirt and debris,
and wash it clean with water.
3. Check the engine cooling fin for dirt and debris, and
clear them with air pressure (not to exceed 205 kPa
(2.1 kgf/cm , 30 psi)).
(1) Engine oil filter (A) Right rear tire
(1) Engine cooling air inlet (A) Left rear tire
(1) Engine cooling fin