Kubota RTV1140CPX, Руководство по ремонту

Страница: 59 / 379

GENERAL
RTV1140CPX, WSM
G-38
Flush Cooling System and Changing Coolant
CAUTION
• Do not remove the radiator cap while coolant is hot. When
cool, slowly rotate cap to the first stop and allow sufficient
time for excess pressure to escape before removing the
cap completely.
1. Stop the engine and let cool down.
2. To drain the coolant, open the radiator drain plug (1) and
remove radiator cap (3). The radiator cap must be removed to
completely drain the coolant.
3. After all coolant is drained, close the drain plug.
4. Fill with clean water and cooling system cleaner.
5. Follow directions of the cleaner instruction.
6. After flushing, fill with clean water and anti-freeze until the
coolant level is just below the radiator cap.
Install the radiator cap securely.
7. Fill with fresh water up to the "FULL" mark on the recovery tank.
8. Start and operate the engine for few minutes.
9. Stop the engine and let cool.
10. Check coolant level of recovery tank and add coolant if
necessary.
IMPORTANT
• Do not start engine without coolant.
• Use clean, fresh water and anti-freeze to fill the radiator and
recovery tank.
• When the anti-freeze is mixed with water, the anti-freeze
mixing ratio must be less than 50 %.
• Securely tighten radiator cap. If the cap is loose or
improperly fitted, water may leak out and the engine could
overheat.
9Y1210293GEG0075US0
Coolant Capacity
5.2 L
5.5 U.S.qts
4.6 Imp.qts
(1) Drain Plug
(2) Rear Tire (L.H.)
(3) Radiator Cap
(4) Recovery Tank A: FULL
B: LOW
KiSC issued 05, 2014 A