Kubota MX5200, Руководство оператора

Страница: 79 / 115

2.1 Adjusting the rear wheels
This section describe the procedure to change the
width of the rear tread.
IMPORTANT :
• Always attach the wheels as shown in the
following figure.
• If you do not attach the rear wheel as the
following figure, transmission parts may be
damaged.
• When re-fitting or adjusting a wheel, tighten the
bolts to the following torques.
(1) Bolt
Bolt (1) Tightening torque
196.0 N
⋅
m to 225.0 N
⋅
m
(20.0 kgf ⋅ m to 23.0 kgf ⋅ m)
[144.6 ft
⋅
lbs to 166.0 ft
⋅
lbs]
Then recheck the wheel after driving the tractor
as follows, and thereafter according to
SERVICE INTERVALS TABLE on page 77.
Driving tractor
200 m (200 yards) and 10 times of shuttle
movement by 5 m (5 yards)
1. Remove the bolts which mount the wheel rim and /
or disk.
2. Change the position of the rim and / or disk (right
and left) to the desired position.
3. Tighten the bolts which mount the wheel rim and /
or disk.
BALLAST
WARNING
To avoid personal injury or death:
• You will need the additional ballast for
transporting the heavy implements. When the
implement is raised, drive slowly over rough
ground, regardless of how much ballast is used.
• Do not fill the front wheels with liquid to
maintain steering control.
1. Front ballast
Add weights if needed for stability and improve traction.
Heavy pulling and heavy rear mounted implements
tend to lift the front wheels.
Add enough ballast to maintain the steering control and
prevent tip over.
Remove the weight when no longer needed.
IMPORTANT :
• Do not overload the tires.
• Add no more weight than indicated in the
following table.
Maximum weight 25 kg x 7 pieces
1.1 Front end weights (option)
You can attach the front-end-weights to the bumper.
Refer to your implement operator's manual for required
number of weights or consult your local KUBOTA
Dealer to use it.
(1) Front end weights (2) Bumper
2. Rear ballast
Add weights to rear wheels if needed to improve
traction or for stability. you should match the amount of
rear ballast to job and remove the rear ballast when it is
not needed.
You should add the weight to the tractor in the form of
liquid ballast, rear wheel weights, or a combination of
both.
IMPORTANT :
• Do not overload the tires.
• Add no more weight than indicated in the
following table.
Maximum weight per wheel 47 kg x 3 pieces
WHEEL ADJUSTMENT TIRES, WHEELS, AND BALLAST
MX5200
75