Kubota LA535, Руководство оператора

Страница: 8 / 59

(1) Handle
(2) Guide bar
(3) Pin holes
(4) Lock pin (A) Point where the handle con-
tacts the guide bar
PRECAUTIONS FOR
OPERATING THE LOADER
• Operate the loader only when properly seated at
the controls. Do not operate the loader from the
ground.
• Move and turn the tractor at low speeds.
• Never allow anyone to get under the bucket of the
loader or reach through the boom when the bucket
is raised.
• Keep children, others, and livestock away when
operating the loader and the tractor.
• Do not walk or work under a raised bucket of the
loader or attachment unless it is securely blocked
and held in position.
• For the stability of the tractor and operator's safety,
add rear ballast to the 3-point hitch and / or to the
rear wheels when using the loader.
• To increase stability of the tractor, adjust the rear
wheels to the widest setting that is suitable for your
application.
• Exercise extra caution when operating the loader
with a raised bucket or attachment.
• Do not lift or carry any person on the loader, in the
bucket, or other attachment.
• Avoid loose fill, rocks, and holes. Loose fill, rocks,
and holes can be dangerous for operation or
movement of the loader.
• Avoid overhead wires and obstacles when the
loader is raised. Contacting the electric lines can
cause electrocution.
• Gradually stop the loader boom when lowering or
lifting.
• Use caution when handling loose or shiftable loads.
• When using the loaders for handling large, heavy,
or shiftable objects, using proper handling
attachments with them is recommended.
• Handling large, heavy objects can be extremely
dangerous due to the following reasons:
– Danger of rolling the tractor over
– Danger of upending the tractor
– Danger of the object rolling or sliding down the
boom of the loader onto the operator
• If you must handle the large, heavy objects, protect
yourself by the following preventive measures:
– Never lift the load higher than necessary to
clear the ground.
– Add the rear ballast to the tractor to
compensate for the load or use the rear
implement.
– Never lift large objects with the equipment that
may permit the large objects to roll back onto
the operator.
– Move slowly and carefully, avoiding rough
terrain.
• Never lift or pull a load from any point on the loader
or any attachments with a chain, rope, or cable.
Otherwise, rollover or serious damage to the loader
may occur.
• Be extra careful when operating the tractor on a
slope. Always operate the tractor up and down, and
never across the slope.
• Do not operate the tractor on steep slopes or
unstable surfaces.
• When operating another implement on a hillside, be
sure to remove the loader to reduce the risk of
rollover.
• Carry the boom of the loader at a low position
during transport. Ensure that you are able to see
over the bucket.
• Allow for the length of the loader when turning the
tractor.
PRECAUTIONS AFTER
OPERATING THE LOADER
• When loader work is complete and parking or
storing, follow the following procedures before
leaving the operator's seat of the tractor.
1. Choose flat, hard ground.
2. Lower the boom of the loader to the ground.
3. Stop the engine.
4. Set the brakes.
5. Remove the key from the ignition.
• Make sure that the removed loader is on stands
and on a hard, level surface.
• Before disconnecting the hydraulic lines, relieve all
hydraulic pressure by moving the controls.
• Do not remove the loader from the tractor without
an approved bucket attached.
SAFE OPERATION
4
LA535