ASSEMBLY INSTRUCTIONS
10
A
The front guard has its mounting holes in different
positions between CAB models and ROPS models.
Referring to the figure below, select their respective
proper mounting holes.
IMPORTANT:
[When installing the old type mower]
A
When the nuts, which is fixing the bolt of the front
guard, contact the front hanger bracket of the mower,
cut the front hanger bracket as shown in the illustration
below.
B
Tightening Bolts and Nuts
Tighten all bolts and nuts with required torque.
A
Before finally tightening all mounting hardware, start
the engine and apply down pressure to the bucket until
the loader raises the front wheels slightly, and make
sure that the mounting pins can be rotated easily.
Tighten all bolts and nuts in this position.
(A) Proper mounting hole
(1) Front hanger bracket
[RCK60-30B]
(A) 30 mm (1.18 in.)
(B) 20 mm (0.78 in.)
[RC72-27B]
(A) 40.5 mm (1.59 in.)
(B) 16.5 mm (0.64 in.)
Location
Bolt / Nut
Required Torque
Main frame
(Front axle
frame)
M14 bolts
147 N m
(15.0 kgf m)
(108 lbf ft)
Main frame
(Clutch housing)
M12 bolts
(pitch 1.75)
80.0 N m
(8.2 kgf m)
(59.0 lbf ft)
Main frame
(Center frame)
M12 bolts
(pitch 1.25)
M12 nuts
90 N m
(9.2 kgf m)
(66.5 lbf ft)
