Kubota KX101-3a2, Руководство оператора

Страница: 77 / 164

Operation
77
•
Press the display selector switch (1) to get the setting for
the left connector. The following message is displayed with
the digit "2" flashing in the display.
•
To adjust the left connector at the arm, either press die
working light button (1) or the service port switch (2). The
display toggles between "0" and "14", depending on the
switch pressed. Set the required value.
• Upon pressing the working light button (1) the flow rate
decreases.
•
Upon pressing the service port button (2) the flow rate
increases.
To change the setting of the right connector one more time, press the display selector switch
again.
•
Turn the starter switch (1) to the STOP position.
When switching the starter switch to the STOP position the flow rate settings will be stored. This makes sure
that upon the next start-up the limited oil flow is switched to the last operating mode.
The figure below shows the possible preferences you can preset using the working light button and the service
port switch.