Kubota KX033-4, Руководство оператора

Страница: 33 / 123

11 CHECKS BEFORE START
C
Glow indicator
The indicator is displayed when the starter key is turned
to the
"RUN" position but the engine requires preheating.
Wait until the indicator goes out, and then start the engine.
B
Warning Lamp
The warning lamp is used to indicate broken wire, short-
circuit, fuel shortage and other problems.
The warning lamp starts flashing in red if any problem
occurs. If the system senses a in warning signal, the
warning lamp starts flashing in yellow.
A
If the warning illuminates, do not just look at the meter;
carry out the appropriate inspection and correction
accordingly.
(See
"REGULAR CHECKS AND MAINTENANCE
WORK" section)
A
If any warnings and problems are displayed, an alarm
buzzer will beep. (See
"LIST OF SCREENS" section
for detail.)
A
Consult your local KUBOTA dealer from details
concerning care and maintenance.
B
LCD for Warning
C
Remaining fuel warning
When the fuel level is very low, the lamp (yellow) starts
flashing and the following message appears in the
display.
A
After a short period of time, the display comes back to
normal.
A
After a short period of time, the message shows up
again.
A
Even while in the normal display mode, the warning
lamp keeps on blinking.
A
To see what warning is being given out, press the
display selector switch. The current warning can then
be identified.
C
Battery charge warning
If the starter key is turned to the "RUN" position without
starting the engine, and the charging lamp stays off, the
charging system has failed. If such occurs, immediately
contact your local dealer for repair.
(1) Glow indicator
(1) Warning lamp (red, yellow)
(1) Charging lamp