Kubota B2650, Руководство оператора, Страница: 40 / 112

20 OPERATING THE ENGINE
A
For a while after the start of regeneration, the engine runs at high speed for warming it up and regeneration of electricity.
A
During the regeneration cycle, do not touch the above levers, and switches (in steps 2, 3, 4, 5), nor change the engine
rpm other than an emergency stop. Otherwise, the regeneration will be interrupted.
A
Never leave the tractor when parked regeneration process is activated.
A
If the parked regeneration cycle is interrupted, the engine rpm is fixed at the idling level for about 30 seconds. For this
period, keep the hand throttle lever at the idle position. Do not move it. It will function again in 30 seconds.
Operating Procedure for Parked Regeneration
1. Park the tractor in a safe area away from buildings, people, and animals.
2. Set the parking brake.
3. Set the speed control pedal to "NEUTRAL" position.
4. Set the speed set lever to "OFF" position.
5. Set the PTO clutch lever to "OFF" position.
6. Lower the implement to the ground.
7. Turn steering wheel so front wheels are in the straight ahead position.
8. Return the engine rpm to the idle speed.
9. Press the DPF INHIBIT switch , and the switch lamp turns "OFF".
10. When the regeneration conditions are satisfied (from 2 to 5 and 8, 9), the parked regeneration switch lamp
start flashing.
11. Press the parked regeneration switch to start the regeneration cycle.
(The switch lamp will stop flashing and remain "ON" constantly during the cycle.)
12. The engine rpm will automatically rise, and the regeneration process will begin.
13. Both indicators stay "ON" while regenerating the DPF.
They turn "OFF" when the cycle is complete.
14. After the lamp turns "OFF", normal tractor work may resume.
When driving in "Regeneration Inhibit" mode, press the DPF INHIBIT switch to turn on the switch lamp.