9
Section 1: Assembly & Set-up
AP-SRT62, & AP-SRT76 Rotary Tillers 321-095MK
7/31/17
Hydraulic Hoses & Couplings
Refer to Figure 1-4:
1.
If attaching small flat face couplers, screw
adapters (#6) to hydraulic hoses (#7 & #8) until tight.
2.
Screw male coupler (#3) to hydraulic hose (#8) until
tight.
3.
Screw female coupler (#4) to hydraulic hose (#7) until
tight.
4.
If using case drain coupler (#5), wrap teflon tape
around pipe threads on end of hydraulic hose (#9)
and screw coupler (#5) to that hose until tight. If
coupler (#5) is not used, customer must supply all
fittings to complete the connection between the skid
steer sump and hydraulic hose (#9).
5.
Thread hydraulic hoses (#7, #8, & #9) through spring
hose loop (#2).
6.Bundle hoses (#7, #8, & #9) together in three places as
shown with cable ties (#1).
Skid Steer Hook-up
Refer to Figure 1-5:
!
DANGER
To avoid serious injury or death:
A Crushing Hazard exists when hooking-up equipment. Do
not allow anyone to stand between skid steer and attachment
while hooking-up to attachment. Do not operate hydraulics
while someone is near the skid steer
or attachment.
!
CAUTION
To avoid serious injury:
Make sure the skid steer hitch is properly attached to the
Rotary Tiller hitch. It must be secured under the tiller’s top
angle bars and lock handles must be locked down with locking
pins extending fully through bottom slots in the tiller hitch. An
improperly attached tiller can fall without warning.
NOTE:
Quick couplers (#3 & #4) are optional and
can be purchased from Kubota in one of two sizes.
Options include small flat face couplers
(#3 & #4) with adapters (#6) or large flat face
couplers (#3 & #4) without adapters (#6).
NOTE:
A 3/8" quick disconnect coupler (#5) is
included with case drain line (#9). If skid steer is not
equipped to receive this coupler, the customer will
need to supply any fittings required to complete the
connection between the 3/8" MNPT threads on case
drain line (#9) and the skid steer sump.
NOTE:
Hooking up against the far right side of the
tiller hitch will center the tiller on the skid steer.
Hooking up against the far left side of the tiller hitch
will side shift the tiller to the right 6".
Hydraulic Hose & Couplings
Figure 1-4
Skid Steer Hook-up
Figure 1-5
1.
Check for and remove all debris in the skid steer and
tiller hitch point areas.
2.
Raise lock pins on skid steer hitch for hook-up.
3.
See note-in-box above step #1.
Drive skid steer
slowly to the far right or far left side of the tiller hitch
making sure the skid steer hitch plate is parallel with
the tiller’s top angle bar.
4.
Rotate top of skid steer tilt arms slightly forward.
5.
Position top of skid steer hitch plate under the top
angled bar and slowly raise loader arms up until its
hitch plate is seated under the top angle bar.
6.
Rotate top of skid steer tilt arms back until skid steer
hitch plate makes full contact with tiller hitch plate.
7.
Lower lock pins on skid steer hitch. Make sure lock
pins go through bottom slots in tiller hitch and are in
lock down position.
37204
37205
Содержание AP-SRT62
Страница 35: ......
