Kubota AP-SC6072, Руководство оператора

Страница: 17 / 42

Section 1: Assembly & Set-up
Table of Contents
AP-SC6072 Skid Cutter 327-321MK 4/6/21
13
Hitch Hook-Up
Refer to Figure 1-1:
DANGER
!
To avoid serious injury or death:
•
A crushing hazard exists when hooking-up and unhooking
the attachment. Do not allow anyone to stand between
attachment and power machine while approaching or
backing away from the attachment. Do not operate
hydraulic controls while someone is near the power
machine and/or attachment.
•
Do not operate cutter with skid shoes higher than 16 1/2"
off the ground. Always use height adjusting safety chain to
limit cutting height. Raising cutter too high will throw
debris at the operator.
1. Make sure hydraulic hoses and height limiting safety
chain do not interfere with hitch hook-up.
2. Drive skid steer slowly to the Skid Cutter making sure
the front hitch plate of the skid steer is parallel with
the Skid Cutter hitch.
3. Tilt top of skid steer hitch plate slightly forward.
4. Place top of skid steer hitch plate directly under the
Skid Cutter top angle bar.
5. Slowly lift skid steer hitch until it fully contacts the
Skid Cutter top angle bar.
6. Slowly rotate skid steer hitch plate back.
7.
Engage skid steer lock handles. Make sure the pins
go through the bottom slots of the Skid Cutter’s hitch
and the handles lock down.
Skid Steer Hook-Up
Figure 1-1
74798
Top angle bar
Bottom slot
Height limiting safety chain: Chain must run under the upper cross
tube and skid steer hitch plate then attach to Skid Steer’s lower
hitch loop. See Figure 1-2.
Male coupler Female coupler
Blade bolt access hole
Zip tie hydraulic hoses together.
Upper cross tube
Hose ring
Case drain coupler
Refer to Figure 1-2
8. Connect the height limiting safety chain to the skid
steer. For additional information on how to adjust the
height limiting safety chain,
see “Height Limiting Safety Chain” on page 14.
Height Limiting Safety Chain (Kubota SVL Shown)
Figure 1-2
NOTE: If the skid steer is not equipped with
hydraulic lock handles, the skid steer must be shut
down and lock handles must be manually engaged.
Refer to
“Skid Steer Shutdown Procedures”
on
page 19.
70031
Safety chain stud
Upper cross tube
Skid steer hitch plate
IMPORTANT:
The height limiting safety chain must
run under the upper cross tube and the skid steer
hitch plate or damage can occur.