Kubota AP-SC6072, Руководство оператора

Страница: 18 / 42

Section 1: Assembly & Set-up
Table of Contents
AP-SC6072 Skid Cutter 327-321MK 4/6/21
14
Height Limiting Safety Chain
DANGER
!
To avoid serious injury or death:
•
Do not operate cutter with skid shoes higher than 16 1/2"
off the ground. Always use height adjusting safety chain to
limit cutting height. Raising cutter too high will throw
debris at the operator.
•
Always secure equipment with solid, non-concrete supports
before working under it. Never go under equipment
supported by concrete blocks or hydraulics. Concrete can
break, hydraulic lines can burst, and/or hydraulic controls
can be actuated even when power to hydraulics is off.
Refer to Figure 1-3:
For safety, the cutter’s rear skid shoes should not be
raised higher than 16 1/2" off the ground (18" maximum
cutting height).
1. Raise cutter’s rear skid shoes slightly less than
16 1/2" off the ground. Secure the cutter with solid
(non-concrete) support blocks.
2. Shut skid steer down properly. See
“Skid Steer
Shutdown Procedures” on page 19.
3. Run height limiting safety chain under the
skid steer hitch plate to the skid steer lower hitch
loop. Thread chain through the hitch loop and back
toward the hitch plate. Connect quick link coupler to a
chain loop as shown in
Figure 1-4
.
4. The SSV65 has two chain loops. A height limiting
safety chain must be attached to both loops to set the
cutting height. An extra chain is necessary to stop
NOTE: Two people may be required to install and
adjust the height limiting safety chain.
deck level and to prevent damage to skid steer arms.
Chains are available through accessories.
SC60 Height Adjustment (SVL Shown)
Figure 1-4
5. Raise cutter up until the height limiting safety chain is
tight. Check height of rear skid shoes.
6. If rear skid shoes are more than 16 1/2" above
ground level, lower cutter and make necessary
adjustments to the height limiting safety chain to limit
rear skid shoe height to 16 1/2" maximum.
7. Tighten quick link coupler nut to secure height
limiting safety chain.
NOTE: When attaching the Skid Cutter to a Kubota
SVL machine, height limiting safety chain (#2)
should be looped around SVL
tie-down bar (#1) and adjusted so that the cutter
cannot be raised over 16.5" off the ground as shown
in Figure 1-4 below.
NOTE:
SSV65 needs two height limiting safety
chains attached to set cutting height.
70032
1 2
16.5"
Nominal Cutting Height (SVL shown)
Figure 1-3
Lower hitch loop
Ground level
Bottom of rear
skid shoes
70033
Height limiting
safety chain
16.5"