Section 4: Adjustments
AP-PS2072 & AP-PS2086 Primary Seeders 313-805MK
7/15/19
31
Level Indicator
Figure 4-4
Level Indicator
Refer to Figure 4-4:
The Primary Seeder operates best when its frame is level
from front to back. Use the level indicator to level the unit .
Leveling when Hooked to a Skid Steer
1.
Before you begin to seed, watch the weighted
indicator (#1) on the level indicator while the Primary
Seeder is on the ground.
•
If weighted indicator (#1) goes above level line
(#2), tilt top of hitch plate slightly forward.
•
If weighted indicator falls below level line (#2), tilt
top of hitch plate slightly back.
2.
Once the level indicator reads level you can begin
seeding. Check level indicator frequently to try and
keep the Primary Seeder level throughout the
operation.
3.
If the weighted indicator (#1) bounces a lot and is
hard to read, slow travel speed enough to stop the
weighted indicator from bouncing.
Leveling when Hooked to a Tractor 3-Point
1.
If not parked on level ground, start the tractor and
move to level ground.
2.
Lower the Primary Seeder until unit is resting on the
ground.
3.
Shut tractor down properly before dismounting. Refer
to
4.
Adjust length of upper center 3-point link until the
weighted indicator (#1) reads level.
72137