background image

 

 

PRINTED IN THE USA © KUBOTA TRACTOR CORPORATION 2019

 

     Code: 77700

-

05187 (Rev. D)

 

■    

MACHINE PREPARATION

 

CAUTION

 

To avoid personal injury:

 

 

Park the machine on a firm and level surface.

 

 

Apply the parking brake if applicable.

 

 

Stop the engine and remove the key from the 

machine if applicable.

 

 

■    

ASSEMBLY PROCEDURE

 

NOTE:

 

 

 

All assembly procedures listed within this 

manual are generally representative of the 

machine model for which the manual is 

written. 

Your machine may be configured 

differently, but the outline for the procedure 

should still be followed. For further support for 

any issues not covered within the pages of this 

manual, please contact your local Kubota 

representative.

 

 

1. Refer to both illustrations on previous page.

 

2. Install the black rubber grommets into the 4 holes in the 

windshield oriented so that the body of the grommet is 

towards the inside.

 

3. Install P

-

Clamps on the front ROPS tube with flats forward 

as shown. Two on each post.

 

4. Hold the windshield in place on the vehicle and fasten 

through each grommet with a bolt and fender washer from 

the front and secure with a small washer and nut on the 

inside of the P

-

Clamp.

 

5. Leave a gap below the windshield and tighten bolts until 

the rubber grommet bulges slightly. 

Do not over

-

tighten or 

the windshield will crack.

 

Отзывы: