Kübler CODIX 554, Руководство пользователя

Страница: 45 / 132

www.kuebler.com Page 11
55 P Pa arra am me ette err sse ettu up p
The parameters have to be set up before
putting the unit into operation.
–
– IIn np pu utt p pa arra am me ette err
The parameters of the scaling slope must
be set up depending on the sensor used.
–
– S Sc ca alliin ng g ssc co op pe e
The correspondence between the input
signal and the displayed value is given by
the scaling slope. The scaling slope is set
up by entering pairs of values.
– – A Alla arrm mss//o ou uttp pu uttss
Either none, one or two alarm values can
be active. Hysteresis and output parame-
ters are also set up. If the set-point is ex-
ceeded, a signal will be sent out at the
corresponding output and the correspon-
ding LED will be switched on.
The alarms themselve are set up in the
operating mode!
–
– M Ma aiin nss H Hu um m FFiilltte err
To reduce operational interference
caused by the 50/60 Hz mains supply you
can choose the local mains frequency.
Where negative values are permitted, the
highest digit will switch from “9” to”–”
and only then to “0”.
Press key
to switch to the next digit.
Enter value: Press key , the value will
be stored. The next menu item appears.
55..11 S Se ettu up p M Mo od de e
To put the unit into set-up mode
1. keep the
key pressed
2. connect the unit with the power supply
3. When the display shows
release the key.
G Ge ettttiin ng g a ac cq qu ua aiin ntte ed d w wiitth h tth he e d diissp plla ayyss a an nd d
kke eyyss
The selection or the settings can be run
through as often as required thanks to the
step-through programming method
M
Me en nu u iitte em m::
The display alternates every 2 seconds
between
E En ntte erriin ng g iin ntto o tth he e m me en nu u::
Either a selection has to be made or a
value has to be set up.
Press the
key . The display stops
alternating.
–
– M Ma akkiin ng g a a sse elle ec cttiio on n::
Pressing the key displays all the pos-
sible settings one after the other.
–
– E En ntte err tth he e sse elle ec cttiio on n::
Press the key. The selected param-
eter will be stored. The next menu item
appears
–
– E En ntte erriin ng g a a vva allu ue e::
The flashing digit indicates that it is en-
abled for entry.
Press the
key, the number will be
incremented.
Menu <–> Selection
english