REVOLEX
®
KX / KX-D
Operating/Assembly instructions
Type AB
KTR-N
Sheet:
Edition:
49413 EN
14 of 22
6
Please observe protection
note ISO 16016.
Drawn:
2019-05-29 Pz
Replacing:
KTR-N dated 2016-11-08
Verified:
2019-06-12 Pz
Replaced by:
Before assembly make sure that the motor shaft is located in
the magnetic center.
Drive the sleeves (component 4) into the bores of the hub
part 2AB (component 2AB) by light blows (see illustration 11).
Illustration 11
Suspend the disk (component 7a) on the shaft for the hub
part 1 (component 1) (see illustration 12).
Please assemble the hubs onto the shafts of the driving and
driven side in a way that the flat faces of the coupling hubs
are flush with the faces of the shafts (see illustration 12).
Illustration 12
Shift the power packs in axial direction until the distance
dimension E has been achieved (see illustration 13). Please
make sure that the motor shaft is located in the magnetic
center.
If the power packs are already firmly assembled, shifting the
hubs axially on the shafts allows for setting the distance
dimension E.
Fasten the hubs by tightening the setscrews
DIN EN ISO 4029 at the tightening torque acc. to table 7.
Align the coupling hubs in a way that the bores for the pins
are flush.
Illustration 13
Illustration 14
!
Please consider permissible shaft
displacements of chapter 4.8!
Insert the pins (component 3a and 3e) into the hub part 1
(see illustration 14).
Screw up the pins to the hexagon screws (component 3.4a)
and tighten them evenly to the tightening torques specified in
table 2 by means of a torque key (see illustration 14).
!
The screws have to be secured against working
loose, e. g. by conglutinating with Loctite
(average strength).
!
Having started up the coupling the tightening
torques of the screws have to be inspected
during usual inspection intervals.
4
Assembly
4.5 Assembly of type KX
