CLAMPEX
®
KTR 150
Operating/Assembly instructions
KTR-N
Sheet:
Edition:
40812 EN
4 of 9
7
Please observe protection
note ISO 16016.
Drawn:
2017-11-29 Shg/Jh
Replacing:
KTR-N dated 2017-04-27
Verified:
2017-11-29 Shg
Replaced by:
Calculation of torque with clamping elements positioned in a row multiple times
1 clamping element
T
total
= T
single
∙ 1.00
2 clamping elements
T
total
= T
single
∙ 1.55
3 clamping elements
T
total
= T
single
∙ 1.85
4 clamping elements
T
total
= T
single
∙ 2.02
Calculation of pressure flange
Illustration 2: Dimensions for calculation of pressure flange
Recommended dimensions of
pressure flanges:
N
1
[mm] ≥ 1.5 ∙ B
D
2
[mm] = D + 12 + M
F1 [mm] = M ∙ 1.3 (with screws 8.8)
F1 [mm] = M ∙ 1.8 (with screws 10.9/12.9)
Please read through these operating/assembly instructions carefully before you mount the clamping set.
Please pay special attention to the safety instructions!
The operating/assembly instructions are part of your product. Please store them carefully and close to the clamp-
ing set.
The copyright for these operating/assembly instructions remains with KTR.
Warning of potentially explosive
atmospheres
This symbol indicates notes which may contribute to pre-
venting bodily injuries or serious bodily injuries that may
result in death caused by explosion.
STOP
Warning of personal injury
This symbol indicates notes which may contribute to pre-
venting bodily injuries or serious bodily injuries that may
result in death.
!
Warning of product damages
This symbol indicates notes which may contribute to pre-
venting material or machine damage.
General advice
This symbol indicates notes which may contribute to pre-
venting adverse results or conditions.
1
Technical data
2
Advice
2.1 General advice
2.2 Safety and advice symbols
