KTM LC4 ADVENTURE R 640 2000, Руководство пользователя

Страница: 20 / 46

ENGLISH
18
Bleeder screw front fork
The bleeder screws
1
should now and then be released a few turns to let
overpressure, if any, escape from the interior of the fork. To do this, place
the motorcycle on a stand with the front wheel lifted off the ground. When
riding the motorcycle mainly on street, it will be enough to have this job
performed in the course of the periodical maintenance service.
!
CAUTION
!
E
XCESSIVE PRESSURE IN THE INTERIOR OF THE FORK CAN CAUSE LEAKS IN THE FORK
. I
F
YOUR FORK IS LEAKING
,
IT IS RECOMMENDED TO OPEN THE BLEEDER SCREWS BEFORE
HAVING THE SEALS REPLACED
.
Checking and adjusting steering head bearing *
Check steering head bearing for play periodicaly. To check this put
motorcycle on a stand so that the front wheel is off the ground. Now try to
move the fork forward and backward. To adjust, loosen the five clamp scr-
ews
2
of the top triple clamp and turn steering stem bolt clockwise
3
until
there is no more play. Don’t tighten the steering stem bolt all the way,
otherwise the bearings will be damaged. With a plastic hammer, lightly rap
on the triple clamp to avoid tension. Re-tighten the five clamp screws with
15 Nm (11 ft.lb).
WARNING
I
F THE STEERING HEAD BEARING IS NOT ADJUSTED TO BE FREE OF PLAY
,
THE MOTORCYCLE
WILL SHOW AN UNSTEADY DRIVING PERFORMANCE AND CAN GET OUT OF CONTROL
.
!
CAUTION
!
I
F YOU DRIVE WITH PLAY IN THE STEERING HEAD BEARING FOR LONGER PERIODS
,
FIRST THE
BEARINGS AND THEN THE BEARING SEATS IN THE FRAME WILL BE DESTROYED
.
At least once a year, the steering head bearings should be greased.
Changing the spring preload of the shock absorber
KTM sets the shock absorber for a driver only, weighing approximately 75
kg (165 lb). If you want to take a passenger with you, of if you weigh con-
siderably more or less than 75 kg (165 lb), you should change the spring
preload accordingly. This is easily done.
NOTE:
– Before changing the spring preload note down the basic setting, e.g.
how many threads are visible above the adjusting ring.
– One rotation of the adjusting ring
5
changes the spring preload by
approximately 1,75 mm (0,07 in).
Loosen the locking ring
4
with the hook wrench from the tool set. Change
the spring preload with the adjusting ring
5
and re-tighten the locking ring.
BASIC SETTING – SPRING PRELOAD
A = 23 mm (0,9 in)
A
4
5
1
2
3