KTM Freeride 350, Руководство пользователя

Страница: 89 / 113

SERVICE WORK ON THE ENGINE
87
B01127-10
–
Push oil screen
3
with the O-rings onto a pin wrench.
–
Push the pin wrench through the opening into the drill hole of the opposite engine
case wall and push the oil screen as far as possible into the engine case.
B01131-10
–
Mount and tighten screw plug
2
with the O-ring.
Guideline
Screw plug, oil screen M20x1.5 15 Nm
(11.1 lbf ft)
–
Mount and tighten the oil drain plug
1
with the magnet and a new seal ring.
Guideline
Oil drain plug with magnet M12x1.5 20 Nm
(14.8 lbf ft)
B01130-10
–
Lay the motorcycle on its side and fill the oil filter housing to about
⅓
full with
engine oil.
–
Insert the oil filter into the oil filter housing.
–
Oil the O-ring of the oil filter cover and mount it with oil filter cover
6
.
–
Mount and tighten the screws.
Guideline
Screw, oil filter cover M6 10 Nm (7.4 lbf ft)
–
Stand the motorcycle upright.
B01119-11
–
Remove the oil filler plug
7
with the O-ring from the clutch cover and fill up with
engine oil.
Engine oil 1.20 l (1.27 qt.) Engine oil (SAE 10W/50) ( p. 103)
Alternative engine
oil Engine oil
(SAE 10W/60)
(00062010035)
( p. 103)
–
Install and tighten the oil filler plug with the O-ring.
Danger
Danger of poisoning
Exhaust gases are poisonous and inhaling them may
result in unconsciousness and/or death.
–
When running the engine, always make sure there is sufficient ventila-
tion, and do not start or run the engine in an enclosed space without an
effective exhaust extraction system.
–
Start the engine and check that it is oil-tight.
Follow-up work
–
Install the engine guard. ( p. 58)
–
Check the engine oil level. ( p. 85)
16.4
Adding engine oil
Info
Too little engine oil or poor-quality engine oil results in premature wear to the engine.