KTM Freeride 250 R AUS 2014, Руководство по ремонту

Страница: 26 / 222

6 FORK, TRIPLE CLAMP
24
200722-10
–
Mount and tighten screw sleeve
9
.
Guideline
Screw sleeve M29x1 46 Nm
(33.9 lbf ft) Loctite ® 241
6.16 Assembling the fork legs
Info
The operations are the same on both fork legs.
Preparatory work
–
Check the fork legs. ( p. 20)
–
Assemble the compression holder. ( p. 22)
–
Assemble the cartridge. ( p. 22)
201439-10
Main work
–
Clamp the inner tube with the axle clamp.
Guideline
Use soft jaws.
–
Mount the special tool.
Protecting sleeve (T512) ( p. 213)
–
Lubricate and mount dust boot
1
.
Lubricant (T511) ( p. 204)
Info
Always change the dust boot, lock ring, seal ring, and support ring.
Mount the sealing lip with the spring expander facing downward.
–
Slide on lock ring
2
.
–
Lubricate and mount seal ring
3
.
Lubricant (T511) ( p. 204)
Info
Sealing lip facing down, open side facing up.
–
Push on support ring
4
.
–
Remove the special tool.
200670-10
–
Sand the edges of the sliding bushes with 600-grit sandpaper, and then clean and
grease them.
Fork oil (SAE 4) (48601166S1) ( p. 202)