KTM F5303V5, Инструкции по установке

Страница: 6 / 21

2 SETUP
4
S04203-01
–
Roll down the film at the sides.
Info
To avoid damaging the motorcycle during unpacking,
leave the other films on the vehicle until you have fin-
ished work on the vehicle.
–
Remove the separate enclosure and unpack it. Check that the
scope of supply is complete using the enclosed packing list.
Info
The procedure for missing components is described in
the Customer Service Manual.
–
Check the vehicle for transport damage.
Info
The procedure in the event of transport damage is
described in the Customer Service Manual.
S04204-01
Warning
Danger of accidents A repaired handlebar poses a
safety risk.
If the handlebar is bent or straightened, the mate-
rial becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged
or bent.
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position the handlebar clamps.
The markings on the handlebar clamps point to the front.
–
Mount the screws, but do not tighten them yet.
–
First, screw the screws onto the longer, higher side of the han-
dlebar supports so that both parts touch.
–
Tighten the screws evenly.
Guideline
Screw, handlebar
clamp M8 20 Nm (14.8 lbf ft)
The lettering on the handlebar is in the middle of the han-
dlebar clamp.