KTM 890 DUKE R 2022, Инструкции по установке

Страница: 6 / 26

2 SETUP
4
Info
The procedure in the event of transport damage is
described in the Customer Service Manual.
F03432-10
–
Remove cable tie(s)
1
. Place the handlebar at the front.
–
Remove the clutch and the brake assembly from the transport
holder.
–
Remove screws
2
from the handlebar clamps. Take off the
handlebar clamps and transport holder.
F03433-10
Warning
Danger of accidents A repaired handlebar poses a
safety risk.
If the handlebar is bent or straightened, the mate-
rial becomes fatigued. The handlebar may break as a
result.
–
Change the handlebar if the handlebar is damaged
or bent.
–
Unpack handlebar and position.
Info
Make sure the cables and wiring are positioned cor-
rectly.
The markings
3
on the handlebar should be at the
height of the gap between the handlebar supports and
the handlebar clamps.
–
Position the handlebar clamps. Mount and tighten the screws
evenly.
Guideline
Screw, handlebar
clamp M8 20 Nm (14.8 lbf ft)
Info
Keep the installed gap widths equal when tightening.
–
Check the handlebar position.
» If the handlebar position is not adjusted as required by the
customer:
–
Adjust the handlebar position. ( p. 12)