ENGLISH
21
5 mm
6
7
4
5
Refilling the front brake fluid reservoir *
When the brake fluid falls to the middle of the inspection glass, new brake
fluid has to be added.
Loosen screws
1
and remove lid
2
and membrane
3
.
Place hand brake cylinder in a horizontal position and fill the brake fluid
reservoir to 5 mm (0,2 in) below the rim with clean brake fluid DOT 5.1
(Shell Advance Brake DOT 5.1). Replace membrane and lid, tighten screws.
Rinse off spilled or overflowing brake fluid with water.
WARNING
– N
EVER USE
DOT5
BRAKE FLUID
! I
T IS BASED ON SILICONE OIL AND OF A PURPLE
COLOR
. S
EALS AND BRAKE HOSES MUST BE ESPECIALLY ADAPTED TO IT
.
– S
TORE BRAKE FLUID OUT OF REACH OF CHILDREN
.
– B
RAKE FLUID CAN CAUSE SKIN IRRITATION
. A
VOID CONTACT WITH SKIN AND EYES
.
I
F YOU GET BRAKE FLUID IN YOUR EYES
,
RINSE WITH PLENTY OF WATER AND CONSULT
A DOCTOR
.
!
CAUTION
!
– D
ON
’
T LET BRAKE FLUID GET IN CONTACT WITH PAINT
,
IT IS AN EFFECTIVE
PAINT REMOVER
.
– U
SE ONLY CLEAN BRAKE FLUID TAKEN FROM A TIGHTLY SEALED CONTAINER
.
Checking the front brake pads
The brake pads can be inspected from below. The linings nust be at least
1 mm (0,04 in) thick.
WARNING
A
T THEIR MOST WORN POINT BRAKE PAD LININGS SHOULD NOT BE THINNER THAN
1
MM
,
OTHERWISE THEY COULD LEAD TO BRAKE FAILURE
. F
OR YOUR OWN SAFETY
DON
’
T PUT OFF HAVING YOUR BRAKE PADS CHANGED
.
!
CAUTION
!
I
F THE BRAKE PADS ARE REPLACED TOO LATE SO THAT THE LINING IS PARTLY OR ENTIRELY
WORN
,
THE STEEL COMPONENTS OF THE BRAKE PAD WILL RUB AGAINST THE BRAKE DISC
,
THEREBY IMPARING THE BRAKING EFFECT AND DESTROYING THE BRAKE DISC
.
Replacing front brake pads *
Press the brake caliper toward the brake disk, to put the brake piston in its
basic position. Remove clips
4
and pull out bolt
5
. Remove brake pads
from the brake caliper. Clean the brake caliper and the brake caliper support
with compressed air. Check the sleeves of the guide bolts for damage, and
grease guide bolts if necessary.
Mount the right brake pad and fix it with the bolt. Mount the left brake pad
and insert the bolt until it stops. Mount the clips.
When mounting the brake pads, be sure to check for correct fit of the
sliding metal-sheet
6
in the caliper support and of the leaf spring
7
.
WARNING
– I
T IS VERY IMPORTANT TO KEEP THE BRAKE DISK FREE FROM OIL AND FATTY MATTERS
.
O
THERWISE
,
THE BRAKING EFFECT WOULD BE STRONGLY REDUCED
.
– A
FTER ASSEMBLY
,
CHECK IF CIRCLIPS HAVE BEEN FITTED CORRECTLY
.
– H
AVING PERFORMED ANY WORK ON THE BRAKING SYSTEM
,
ONE MUST ALWAYS
ACTUATE THE HAND BRAKE LEVER OR FOOT BRAKE LEVER
,
RESPECTIVELY SO AS TO
ENSURE THAT THE BRAKE PADS WILL LIE AGAINST THE BRAKE DISK AND THE PRESSURE
POINT IS ESTABLISHED
.
min.
1 mm
4
4
5
1
3
2
