KTM 50 SX PRO JUNIOR LC 2003, Руководство пользователя

Страница: 18 / 35

ENGLISH
17
1
2
3
Checking and adjusting the steering head bearing (50 SX
SENIOR) *
The steering head bearing should be checked regularly for play. To check,
support the motorcycle frame and lift the front wheel off the ground. Now
try to move the fork back and forth – you should not feel any play. To
adjust, loosen both clamping screws
1
on the upper triple clamp and loosen
the steering head screw
2
by a few turns. Lift the triple clamp slightly and
turn the adjusting nut
3
until hardly any play is left. Never tighten the
adjusting nut since you might damage the bearing. Tighten the steering
head screw to a torque of 10 Nm and the 2 clamping screws to 15 Nm.
WARNING
I
F THE STEERING HEAD BEARING IS NOT ADJUSTED TO BE FREE OF CLEARANCE
,
THE
MOTORCYCLE WILL EXHIBIT UNSTEADY DRIVING CHARACTERISTICS AND CAN GET OUT OF
CONTROL
.
! CAUTION !
– T
HE HANDLEBAR MUST MOVE EASILY
. O
THERWISE THE BEARINGS WILL BE DAMAGED
.
– I
F YOU DRIVE WITH PLAY IN THE STEERING HEAD BEARING FOR LONGER PERIODS
,
THE
BEARINGS AND SUBSEQUENTLY THE BEARING SEATS IN THE FRAME WILL BE DESTROYED
.
At least once a year, the steering head bearings should be smeared with
waterproof grease (Shell Advance Grease).
How to change the handlebar position
The handlebar position can be readjusted by 22 mm (0.9 in). The upper
triple clamp
4
includes 2 bores arranged at a distance of 15 mm (0.6 in)
from one another. The bores at the handlebar support
5
are offset from the
center by 3.5 mm (0.13 in). Accordingly, you can mount the handlebar in
4 different positions.
For this purpose, remove screws
6
of the handlebar clamps and screws
7
of the handlebar support. Position handlebar support, and tighten screws
7
to 40 Nm. Mount handlebar and handlebar clamps, and tighten screws
6
to 20 Nm. The gap between the handlebar support and handlebar clamps
should be the same size in the front and in the rear.
! CAUTION !
T
HE SCREWS
7
MUST BE SECURED WITH
L
OCTITE
243.
4
5
6
7
15 mm
3,5 mm
1
2
3