KTM 450 SX-F, Руководство пользователя

Страница: 31 / 152

RIDING INSTRUCTIONS 8
29
8.9 Shifting, riding
Warning
Danger of accidents If you change down at high engine speed, the rear wheel blocks and the engine
races.
–
Do not change into a low gear at high engine speed.
Info
If unusual noises occur while riding, stop immediately, switch off the engine and contact an authorized
KTM workshop.
First-gear is used for starting off and for steep inclines.
–
Shift into a higher gear when conditions allow (incline, road
situation, etc.). To do so, release the throttle while simultane-
ously pulling the clutch lever, shift into the next gear, release
the clutch lever and open the throttle.
–
If the cold start button was pushed while starting, open the
throttle briefly and release the throttle grip or turn the throttle
grip forward.
The cold start button goes to the basic position.
–
After reaching maximum speed by fully opening the throttle
grip, turn the throttle back so it is ¾ open. This will barely
reduce the speed, but fuel consumption will be considerably
lower.
–
Only open the throttle as much as the engine can handle
–
abrupt throttle grip opening increases fuel consumption.
–
To shift down, apply the brakes and close the throttle at the
same time.
–
Pull the clutch lever and shift into a lower gear, release the
clutch lever slowly, and either open the throttle or shift again.
–
Switch off the engine if you are likely to be running at idle
speed or stationary for a long time.
Guideline
≥
1 min
–
Avoid frequent or lengthy slipping of the clutch. This causes
the engine oil, engine and cooling system to heat up.
–
Ride at a low engine speed instead of at a high engine speed
with a slipping clutch.
F03642-10
Condition
Quickshifter activated.
–
If the quickshifter is activated, you can shift up in the
engine speed range shown without pulling the clutch lever.